建筑垃圾对雨水径流中Cu的吸附特性

以砖混建筑垃圾为研究对象,采用人工模拟雨水,通过静态和动态吸附实验研究了不同粒径粒级建筑垃圾对雨水径流中Cu的吸附效果。结果表明,准二级动力学模型比准一级动力学模型能更好地描述建筑垃圾对Cu的吸附过程;Freundlich等温模型能较好地拟合其等温吸附过程;不同粒径粒级建筑垃圾均对雨水径流中的Cu具有较好的净化效果,去除率均超过90%,粒径粒级越小,对Cu的净化效果越好,但其渗透性能越差;建筑垃圾的粒径粒级对Cu的吸附平衡时间、吸附速率和吸附量具有重要影响,粒径粒级2.36~4.75 mm的建筑垃圾对Cu的平衡吸附速率和平衡吸附量最大,分别为4.1μg/min和12.4μg/g。     

植物内重金属的赋存形态及分布特征分析方法研究进展

植物内重金属分析不仅有助于阐述重金属迁移转化规律,揭示植物修复机理,也是监测评价大气、水及土壤环境重金属污染状况的重要依据。研究针对植物样品中重金属赋存形态及分布特征的分析方法进行综述,分别介绍了其原理、优缺点及应用。提出制定统一高效的分析检测方法,深化植物内重金属的赋存形态及分布特征与环境相关性的研究以及建立数据共享平台是植物样品重金属信息分析方法的未来发展方向。     

绍兴市典型印染废水中重金属锑排放现状及排放源调查

分析和统计的86家印染工业企业当中,废水总排口中的总锑超标率为25.6%,质量浓度0.050 mg/L以下较低排放浓度所占比例最大,达62.8%。印染废水锑排放源主要有涤棉和涤纶化纤类布料的染色、印花工艺废水,碱减量工艺废水等,工业液碱、废酸以及硫酸铝污水处理剂等原料当中含锑浓度较高。印染废水经污水处理厂集中纳管深度处理后,锑排放浓度较低,锑去除效率最高达到88.0%,大大降低了环境地表水体锑污染的风险。     

Comparative evaluation of sizing of metal hydride (MH) hydrogen storage tank filled with different alloys

This study presents a comparative analysis of sizing of metal hydride tank filled with different alloys. Alloys include solid solutions and intermetallic compounds of the generic families AB₅, AB₂, AB, A₂B. The effects of the different alloys on the sizing of metal hydride hydrogen storage tanks are complicated and depend on many factors. In this paper, a thermoeconomic optimization analysis with a simple algebraic formula was presented for the estimation of optimum metal hydride tank surface area for heat transfer enhancement. The optimum area of the metal hydride tank filled with commercially available different alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) was evaluated and compared by the developed method. The optimum net savings and the value of payback were determined for four alloys. It is found that mathematical model can be employed for the determination of optimum metal hydride tank design and increasing net savings according to alloy types. The optimum areas of the tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) were calculated as 0.136, 0.130, 0.133, and 0.173 m², respectively. The optimum net savings for tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) are about 461.0, 409.3, 419.6, and 979.6 $ and the values of payback are about 1.98, 2.1, 2.17, and 1.37 years, respectively. Excessive area of the metal hydride tank would not be as economical as the optimum tank area. Thermal management of metal hydride tank must be designed for optimum points calculated at which maximum savings occur.     

环境磁学在城市地表灰尘重金属污染研究中的应用

随着环境问题日渐突出,地表灰尘重金属污染日益成为研究热点。单纯采用化学方法监测重金属污染具有一定局限性,环境磁学方法以其简便、快捷、经济且无害化的特点在城市重金属污染研究中广为应用。通过文献调研,综述环境磁学在城市地表灰尘重金属污染研究中的应用与研究进展,阐明重金属的主要来源,简述环境磁学的诸多参数,分析磁学参数与重金属的关系,并通过对比不同的磁学分析方法,探讨环境磁学方法在城市地表灰尘重金属污染研究中存在的问题及其发展趋势。     

Adsorption studies on coir pith for heavy metal removal

Biosorption efficiency of coir pith, a waste product from coir industry, was investigated in this study for the removal of metallic pollutants such as Ni, Cu and Zn from aqueous solutions. The disposal of coir pith is a major problem associated with the coir industries, especially working in the small-scale sector. The present study explores the effectiveness of utilization of coir pith, an accumulating waste, as a biosorbent for heavy metal removal. Batch mode studies were done to evaluate the efficiency of removal of metals under varying adsorption conditions of pH, metal concentration and contact time. Characterization studies of the biosorbent and SEM analysis were done. Kinetic modelling studies were tried using Lagergren pseudo-first-order and second-order models. Equilibrium studies were done using well-known Freundlich, Langmuir and D–R isotherm models. It was found that all isotherms are fitting well indicating the efficiency of coir pith as an adsorbent of heavy metals. The applicability of all the three isotherms to the sorption processes shows that both monolayer adsorption and heterogeneous energetic distribution of active sites on the surface of the adsorbent are possible. Due to the abundance and low cost of these materials, adsorption technologies developed can act as good sustainable options for the future in heavy metal removal from industrial effluents.     

Relationship between groundwater cadmium and vicinity resident urine cadmium levels in the non-ferrous metal smelting area,China

● This study systematically examined the relationship between groundwater Cd and UCL. ● The study covered 211 UCL and sociological characteristic from nine groundwater samples. ● We found a significant positive correlation between groundwater Cd and UCL. ● Smoking status and education level also significantly affected UCL. Cadmium (Cd) has received widespread attention owing to its persistent toxicity and non-degradability. Cd in the human body is mainly absorbed from the external environment and is usually assessed using urinary Cd. Hunan Province is the heartland of the Chinese non-ferrous mining area, where several serious Cd pollution events have occurred, including high levels of Cd in the urine of residents. However, the environmental factors influencing high urinary Cd levels (UCLs) in nearby residents remain unclear. Therefore, 211 nearby residents’ UCLs and the corresponding sociological characteristics from nine groundwater samples in this area were analyzed using statistical analysis models. Groundwater Cd concentration ranged from 0.02 to 1.15 μg/L, aligning with class III of the national standard; the range of UCL of nearby residents was 0.37–36.60 μg/L, exceeding the national guideline of 0–2.5 μg/L. Groundwater Cd levels were positively correlated with the UCL (P < 0.001, correlation coefficient 95 % CI = 9.68, R² = 0.06). In addition, sociological characteristics, such as smoking status and education level, also affect UCL. All results indicate that local governments should strengthen the prevention and abatement of groundwater Cd pollution. This study is the first to systematically evaluate the relationship between groundwater Cd and UCL using internal and external environmental exposure data. These findings provide essential bases for relevant departments to reduce Cd exposure in regions where the heavy metal industry is globally prevalent.     

乌鲁木齐市不同区域大气降尘中重金属污染及来源分析

为进一步了解城市不同区域间大气降尘中重金属含量及其差异性,沿城市走向梯度布设降尘采样点采集样品。采用电感耦合等离子体原子发射光谱(ICP-AES)仪测定样品中Cu、Cr、Mn、Fe、Ni、Zn、Cd、Pb和As等重金属含量,并计算富集因子来判断不同区域间的污染源类型,通过因子分析方法探讨污染的来源。结果显示,所测重金属元素中除Mn外,均受到人为源的影响,且十分严重。从贡献率来看,不同区域间第一因子的贡献率虽有差异,但均为来自土壤的风沙扬尘造成;第二因子的贡献率也不尽相同,主要是燃煤产生的污染;第三因子出现了差异,市南区和市北区主要是受金属冶炼的影响,而市中区的影响可能来自垃圾焚烧;市南区未出现第四因子,而市中区和市北区的污染源也不相同。分析表明,城市大气降尘污染依然严重,做好防控风沙和建筑扬尘,减少煤炭消耗,调整能源结构和产业布局是整体减少大气降尘的关键。     

SGA对垃圾焚烧飞灰中重金属的固化性能研究

根据EPA1311、HJ／T299—2007、HJ／T300—2007和HJ557—2009等国内外不同标准，研究了深圳某垃圾焚烧发电厂垃圾焚烧飞灰的浸出毒性，探讨了六硫代胍基甲酸（sixthioguanidineacid，SGA）、二甲基二硫代氨基甲酸盐（sodiumdimethyldithiocarbamate，SDD）和Ca（OH）2浓度对垃圾焚烧飞灰中重金属的固定性能的影响。研究结果表明，随着浸提液pH的降低，该厂焚烧飞灰中大部分金属元素的浸出量增大，焚烧飞灰浸出液中的cd、Ni、Ph和zn浓度分别超过国家危险废物鉴别标准（GB5085．3—2007）规定值的4．75倍、1．47倍、6．72倍和2．20倍，属于危险废弃物，必须进行稳定化处理。当固化剂SGA加入量为0．1mol／kg时，稳定化后的重金属浸出浓度已经低于危险废物鉴别标准，且对Cd、Cr、Cu和Pb的固化性能优于SDD和Ca（OH）2；当固化剂SGA、SDD和Ca（OH）2加入量为0．5mol／kg时，稳定化后的焚烧飞灰重金属浸出浓度均低于国家危险废物鉴别标准（GB5085．3-2007）中的规定值。与SDD和Ca（OH）：相比，SGA对垃圾焚烧飞灰中重金属的固化处理更具有优势。     

一株抗Cd~（2＋）菌株的筛选及其吸附性能

Cd2＋为一种毒性金属元素,为了实际解决污水中低浓度重金属污染,实现污水达标排放,通过12C6＋重离子束辐照诱变技术筛选到一株耐受Cd2＋的菌株C2,研究其对Cd2＋的抗性和低浓度Cd2＋的吸附性能表明,Cd2＋浓度≤100 mg/L时,C2菌株可以生长繁殖,但随Cd2＋浓度升高受到抑制;SEM分析表明,受到Cd2＋胁迫时,C2产生大量胞外产物与Cd2＋形成络合物;吸附过程中菌粉表面空隙得到填充,形成凸起;红外光谱分析表明,吸附过程中的主要作用基团为醇羟基O—H键、氨基和酰胺基团;C2菌粉和固定化菌球都对Cd2＋有较好的吸附能力,菌粉吸附效果比固定化菌球稍好;菌粉和固定化吸附剂的最佳吸附初始pH值为5~6.0,最佳投加量分别为1.0 g/L和10 g/L（实际含菌量为1.0 g/L）;Cd2＋浓度在2~20mg/L时,在最佳吸附条件下,菌粉和固定化吸附剂对Cd2＋的吸附率均在90%左右;2种吸附剂吸附过程与Langmuir等温模型和拟二级动力学模型拟合最佳;热力学研究表明吸附反应均能自发进行。以上研究结果表明,C2菌粉和固定化吸附剂均可用于污水中低浓度Cd2＋的去除。